Every technician is IICRC certified and has handled ceiling water damage repair many times. You get a clear plan before any work starts.
The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
We look at the damage, explain what it needs and give you a written price before we start.
You do not have to work out how bad it is on your own. Call, tell us what you see, and a Manchester technician will explain the next step and what it should cost.
The stain overhead comes at the end of the story, not the beginning. Before any mark shows, water has traveled down a joist, saturated the insulation and collected on top of the drywall. It could come from an upstairs bathroom, plumbing inside the ceiling, an AC condensate line or the roof. Nothing is repaired until the origin of the water has been tracked down.
Painting over the stain does not fix it. While the space overhead stays damp, the stain returns, and within 24 to 48 hours mold can begin on the drywall paper. The opening is kept as small as the damage allows, wet insulation comes out, joists and surrounding drywall are dried, and the area is patched, textured and painted to blend. If the ceiling has started to droop, treat it differently. Keep clear of that area and phone us.
Water runs along joists and soaks into insulation. Because the panel soaks from its top side, nothing may look wrong from underneath.
You see the first ring, along with blisters in the paint. Mold can begin on the drywall paper and the wet insulation presses down on the panel.
The panel turns soft and starts slipping off its fasteners. Between the joists the surface dips, joints split apart and a musty smell arrives below.
Waterlogged sections can fall, bringing wet insulation with them. By now mold has settled into the space above, and the area needing repair has grown considerably.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Ask a Tech: (612) 464-8286| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Ceiling paint and texture | Texture still firmly attached, with staining that primer can seal | Texture that flakes or paint that blisters and peels |
| Insulation above | Lightly damp fiberglass that can be dried in place | Wet cellulose of any kind, plus batts flattened by water |
| Light fixtures | Fixtures that stayed dry and pass an electrical check | Fixtures and junction boxes that took on water |
| Ceiling joists | In most leaks, since solid lumber tolerates a short soaking | Only where a long term leak has rotted the wood |
| Crown molding and trim | Solid wood trim that dries straight with tight joints | MDF or foam trim that swelled, split or came loose |
Recessed lights, fans and junction boxes sit right in the wet zone. Water in a fixture can short the circuit, so switch off the breaker for that room.
The wet spot is often not below the leak, since water rides pipes, ducts and joists before it falls. Cutting in just under the mark may leave damp areas elsewhere untouched.
The structure on the upper side, attic boards or the floor of the next story, tends to be wet too. We check that level as well, because drying only the ceiling leaves moisture behind.
The top side of the drywall and the insulation resting on it stay wet long after the surface feels dry, which is where mold tends to grow unseen.
The first job is locating the starting point, which involves meter readings, a thermal camera and a look at whatever is over the ceiling. The leak has to be stopped before repairs make sense.
We cut power to any wet fixture and move or cover the furniture underneath. If the ceiling is holding water, we release it in a controlled way and catch it.
Wet insulation is removed along with any drywall that cannot stay. The joists and nearby ceiling are dried with air movers plus a dehumidifier, and antimicrobial goes on wherever the water was dirty.
After the meter shows normal levels, new insulation and drywall go up, joints are taped and finished, the texture is matched and a stain blocking primer goes on ahead of paint.
Have a different question? Call us and we will answer it over the phone.
Call (612) 464-8286Don't wait for small problems to become expensive emergencies. Call Manchester Restoration for fast, reliable service.
Call (612) 464-8286 Now