You focus on your home. We put together the photos, readings and reports your insurance company needs.
The sooner drying starts, the less there is to repair. Our phones are answered around the clock, with same-day visits when available.
Certified technicians, professional drying equipment and moisture readings you can see for yourself. No guesswork.
You do not have to work out how bad it is on your own. Call, tell us what you see, and a Manchester technician will explain the next step and what it should cost.
Drywall acts like a wick. When water reaches the bottom of a wall, the gypsum and paper draw it upward, often a foot or more above the level the water ever reached on the floor. From the room, the surface may seem dry and sound even though the hidden face and the insulation are saturated. Looks cannot be trusted here, so every wall gets tested with a meter.
Plenty of walls that get wet can stay. Drywall that got wet with clean water and is still firm can often be dried in place, sometimes by removing the baseboard and moving air through small holes into the cavity. If the drywall has gone soft, crumbles, shows mold or took in dirty water, we do a flood cut, meaning a level cut over the damaged area with all material beneath it removed.
We scan each wall with a moisture meter and thermal camera and mark how high and how far the water traveled, including the opposite side and adjoining rooms.
You get a straight answer on what can be dried where it is and what must be removed, judged by the category of water, the time it sat and the firmness of the drywall.
Where the drywall stays, the trim is pulled and airflow is sent inside the wall. Walls that cannot be kept get a flood cut along a level line, with the wet insulation pulled.
Drying typically takes 3 to 5 days of air movement and dehumidification before the framing and surviving drywall meter dry. The rebuild follows with fresh insulation, drywall installation and finishing, trim and a coat of paint.
Moisture enters where the panel meets the floor and wicks upward from there. The trim and the framing plate at floor level get wet too.
Moisture keeps climbing, the baseboards puff up and blisters form in the paint. Inside the cavity, the paper face becomes a place mold can begin.
The gypsum core turns soft and its paper starts to separate. Within the wall the insulation sags, a smell develops and mold moves over the back of the panel.
Mold and the start of decay show up on framing that has been wet the whole time. The amount of removal and reconstruction grows considerably.
On an exterior wall, water can soak the sheathing behind the insulation. It gets a moisture reading prior to closing, since it holds dampness a long time.
It slips beneath the bottom plate and reaches the closet or room on the other side. Our team inspects each wet wall from both sides, plus the floor running beside it.
Drywall hidden in back of cabinetry and built-in units tends to be missed and dries very slowly. Checking under the cabinet base and on the reverse face tells us if it is wet.
Water pools at the same height as most receptacles and cable runs. Leave the outlets on a damp wall alone until someone has checked the circuit.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Call (612) 464-8286| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Wall insulation | Rigid or spray foam of the closed cell type, which sheds water | Wet fiberglass or cellulose, which slumps and stays damp |
| Drywall | Clean water, caught early, still hard and flat | Gray or black water contact, mold, swelling or loss of firmness |
| Plaster walls | Plaster that stays hard and bonded once dry | Plaster that crumbles to powder or has come loose from its backing |
| Wall studs | Sound lumber, which dries well once the cavity is open | Just sections harmed by rot or severe mold |
| Paint and wallpaper | Painted surfaces with no blistering after the wall reads dry | Vinyl wallpaper that traps moisture, and any peeling finish |
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (612) 464-8286Take action now and prevent costly damage. Manchester Restoration is ready to help.
Call (612) 464-8286 Now